PDGA Discussion Board - View Single Post - Ask Hero about Discraft ( or anything else)

mgaffney · Apr 20 2008, 10:54 PM

. When were the original mold Preds produced?

2. In what plastics?

3. How many runs?

4. Am I likely to find an OP Z?

The old mold predator was done in x plastic first run only.
The only way to tell a first run is there is no stability rating printed on the disc.
The subsequent runs have a little added to the bottom of the lip. They stand a bit taller when laid flat.
most of the first run Z preds are ghost stamped with a z in the middle. they are all the new mold, I have a proto z pred that is the new mold also.
Yes the tsunami is the old mold pred in better plastic, I carry 3 in my bag. I used up almost all my old mold preds, and switched to the tsunami because I never see them on ebay. Im kinda glad I ran out tsunamis season really well, my old mold X preds never really did.

Gaff

Apr 20 2008, 10:54 PM	#537
mgaffney Community Member Join Date: Aug 2006 Location: Mesa, AZ Posts: 73	Re: Z Predator . When were the original mold Preds produced? 2. In what plastics? 3. How many runs? 4. Am I likely to find an OP Z? The old mold predator was done in x plastic first run only. The only way to tell a first run is there is no stability rating printed on the disc. The subsequent runs have a little added to the bottom of the lip. They stand a bit taller when laid flat. most of the first run Z preds are ghost stamped with a z in the middle. they are all the new mold, I have a proto z pred that is the new mold also. Yes the tsunami is the old mold pred in better plastic, I carry 3 in my bag. I used up almost all my old mold preds, and switched to the tsunami because I never see them on ebay. Im kinda glad I ran out tsunamis season really well, my old mold X preds never really did. Gaff