Quote:
Quote:
Why would I go ask Dave D when I have worked in a frisbee factory. Plastic shrinkage has NO effect on how well the mold is packed out though.
|
HAHAHAHAHAHA...
|
I think the issue is
your assumption on
your terminology. With discs, not being packed out would be dips and dents anywhere as well as some curvature on the inside rim wall. But post production cooling (Either table or fixture) has nothing to do with being a whole part.
Quote:
...and stay way from the dome at the rim. Look for a smooth top near the rim
|
Again, technically this is the flight plate coming off the shoulder. The rim is technically the wing, which is below the parting line
I mean no disrespect in my comments, just confused on what you are basing your oppinions on. Mine are based on first hand expirience.